Ride-On Mower Repair glossary
The terms you'll come across, explained in plain English.
- Anti-scalp rollers
- Small wheels or rollers on the edges of a cutting deck that lift it over bumps so the blades do not cut into the soil.
- Carburettor
- The part that mixes petrol with air before it enters the engine. Its tiny jets block easily with gum from stale fuel, causing starting and running problems.
- Cutting deck
- The steel or composite housing under a ride-on mower that holds the blades, spindles and pulleys and controls how grass is cut, collected or discharged.
- Deck belt
- The rubber V-belt that transfers power from the engine to the blade spindles. A stretched or glazed belt slips, slowing the blades and causing clogging.
- Deck levelling
- Adjusting the deck so it sits level from side to side and slightly lower at the front, giving an even cut across the full width.
- Freewheel lever
- A lever on hydrostatic mowers that releases the transmission so the mower can be pushed by hand. Leaving it engaged stops the mower driving.
- Fuel stabiliser
- An additive mixed with petrol to slow its breakdown during storage, helping prevent gum and varnish forming in the carburettor over winter.
- Hydrostatic transmission
- A drive system that uses hydraulic fluid instead of gears, giving smooth speed control with a pedal. Many domestic lawn tractors use a sealed hydrostatic unit.
- Idler pulley
- A free-spinning pulley that guides a belt and, with a spring, keeps it under tension. Worn idlers squeal, wobble and wear out new belts quickly.
- Lawn tractor
- A ride-on mower with the engine at the front and a cutting deck slung underneath between the wheels, usually with a rear grass collector. The most common type of domestic ride-on in the UK.
- Mulching
- Cutting grass clippings very finely and returning them to the lawn instead of collecting them. Many decks can mulch with a plug or kit fitted.
- Seat safety switch
- A switch under the seat that stops the engine or blades if the operator leaves the seat while the blades are engaged. It must never be bypassed.
- Solenoid
- An electrical switch that carries the heavy current from the battery to the starter motor when you turn the key. A faulty solenoid often causes a click but no crank.
- Spindle
- The bearing housing a mower blade is bolted to. It lets the blade spin at high speed; worn spindle bearings cause noise, vibration and an uneven cut.
- Zero-turn mower
- A ride-on mower steered by two levers that control each rear wheel independently, letting it turn on the spot. Fast and manoeuvrable, but more costly to buy and repair.
Get a free ride-on mower repair quote
Tell us what you need and we'll come back with a clear price.
Request a quote